Bottomline Traction Products - Home of the Dominator and Aggressor wearbars for snowmobiles.

The DOMINATOR™Classic Stainless Push-Thru Carbide Stud offers traction performance of the famous push-thru design with the unsurpassed strength and the long life of 5/16” shanked stainless steel coupled with a long wearing carbide tip. DOMINATOR™ Classic Stainless Push-Thru Carbide Studs are easy to install with the positive Torx® head. The 1- inch round head is chamfered so suspension components easily run on them without causing interference or abnormal wear and tear. Complete with stainless steel nylock nut and clear anodized aluminum backers for light-weight installation. Also available in bulk. Visit our website for recommended stud usage for the type of riding you do.

48 Clamshell Packs

Part No.	Description	Length
SS875-48	Stud, Nut, Backer	.875
SS1000-48	Stud, Nut, Backer	1.000
SS1125-48	Stud, Nut, Backer	1.125
SS1250-48	Stud, Nut, Backer	1.250
SS1375-48	Stud, Nut, Backer	1.375

1000 Bulk Packs

Part No.	Description	Length
SS875-1000	Stud, Nut, Backer	.875
SS1000-1000	Stud, Nut, Backer	1.000
SS1125-1000	Stud, Nut, Backer	1.125
SS1250-1000	Stud, Nut, Backer	1.250
SS1375-1000	Stud, Nut, Backer	1.375
AB-1000	Aluminum Backer	-

SELECTING THE RIGHT STUD

Select a stud that will measure roughly 1/4" to 3/8" above the track lug. Measure the lug from the base of the lug to the tip. Select the number of studs required according to your riding style and horsepower of the snowmobile you plan on installing them on. The chart below is a good starting point, but you may want to adjust the number of studs depending on your needs. the most basic stud pattern is the 96 pattern. Studs should be installed evenly on the track with 70% of them in the center belt of the track. they should also be staggered so that you get multiple "scratch lines".

HP/STUD RATIO CHART

TRAIL RIDING AGGRESSIVE TRAIL RACING

No. of Studs Horsepower No. of Studs Horsepower No. of Studs Horsepower

24 20-30 72 35-50 140-180 50-75

48 30-50 96 50-75 180-240 75-100

72 50-75 120 75-100 240-288 100-130

96 75-100 144 100-110

168 110-120

Our Classic Stainless Push-Thru Studs provide a margin of safety and are designed as an added safety device for your snowmobile track. Unforeseen ice and smooth spots are a snowmobile safety hazard and can be the cause of losing control of your snowmobile. Studs in general are intended to compensate for these conditions. They can, however, cause damage to paved surfaces and caution should be taken while crossing paved trails and highways to reduce any damage caused. Damage can also occur on the stud itself and reduces its effectiveness. Please be cautious while crossing paved surfaces. DO NOT spin the track. Proceed slowly. Warranty is void if failure is due to misuse or abuse.